How it Works

The Bounce Dryer Bar works much like your dryer sheets. Once placed inside of your dryer where it stays secure, heat, plus the tumbling movement of your clothes, allows for the transfer of fabric softener.

Install & Replace

Over time, you'll notice the bar beginning to wear away, and usually in about 2 or 4 months*, depending on the size of the bar, it will need to be replaced.

1.) Remove paper backing from Bounce Dryer Bar.
2.) Press firmly onto dryer drum. Smooth surfaces work best.
3.) In about 2 or 4 months, simply remove the cartridge and replace with a new one.

*Depends on frequency of use & your dryer settings.

Safe for your dryer and your clothes

The Dryer Bar, is of course, totally safe for your household dryer and it's compatible with any household dryer type. In fact, it's even recommended by the Kenmore brand!

The same goes for fabrics*. Rest assured, we've tested the dryer bar with literally thousands of loads and with many types of garments.

* Not for use in children's sleepwear or other garments labeled as flame resistant as it may reduce flame resistance

Bounce Dryer Bar: Frequently Asked Questions

Is it safe for my dryer?

Yes, the Dryer Bar has been tested to show that it's safe for both HE and regular household dryers. In fact, it's even recommended by the Kenmore brand.

Will it stick safely in my dryer?

When installed properly, the adhesive will remain stuck to the dryer drum until removed, thus locking the bar safely in place.

How do I replace it?

You'll know it's time to insert a new Dryer Bar when the word "Replace" appears on your old one. Simply pull back the wings on either side of the holder, and the old bar should slide right out. Then simply snap the new one in place.

Can I remove the Dryer Bar holder?

Generally, you shouldn't need to replace your dryer bar holder to replace your bar. If for some reason you decide to remove the Dryer Bar holder, you can do so in just 3 easy steps:

1.) Turn your empty dryer on the High/Cotton setting for 5 minutes to soften the adhesive.
2.) Wait several minutes for the dryer drum to cool, then use a plastic spatula to gently pry the holder off. Do not use anything metal, as metal can scratch the dryer drum surface.
3.) Use the spatula to rub off any excess residue. You can also use a wet dishtowel with some mild soap like Dawn® Dish Detergent.